The sides have ben leveled to fit a domed back that tapers from the back 4.25 inches to the heel, 3.5 inches.
I did this on a powered domed sanding disk that I will show in subsequent posts.
This is going to be the lining for the sides. Since its solid lining rather than kerfed, it has to be prebent. I do that over this hot pipe. It'selectrically heated
Four pieces of lining bent and ready to be glued in. Since it takes two pieces for each edge of each side, that means I will need a total of ....ah..(lets see 2 edges per side, times 2 sides times 2 pieces per edge) eight pieces total. I'll need to bend 4 more.
No comments:
Post a Comment